Menu
0
Canada Wide Shipping
Edmonton's Largest Selection
Special Orders and Preorders
Local Delivery or Same Day Pickup
We require proof of proper enclosure for all animals. | Regular Store Hours: Sunday 11-6pm | Monday to Saturday 11-7pm
20Nov2026
Show Us Your Setup Before Pickup

Show Us Your Setup Before Pickup

Before your animal goes home, we require photos of the enclosure they’ll be living in. This gives us a chance to catch anything they might need while there’s still time to make a change. If the setup doesn’t meet the needs of that species, we’ll explain what needs adjusting and why. We only send an animal home once we’ve approved their enclosure.

Reptiles move between warmer and cooler spots to regulate their body temperature, which affects their metabolism and how well they digest food. The right humidity helps them stay hydrated and shed properly. We want you to feel confident caring for your critter and to see them happy and thriving for years to come.

Is the enclosure ready?

Run the finished setup through a full day and night before pickup. Ask us about your species temps and humidity to check the readings below, and take the temperature directly under the heat lamp aka basking spot, if applicable. 

  • Measure the space your animal can use. Check the inside length, width and height against the recommended enclosure size for your species and its current life stage. Some animals require a smaller grow out terrarium before moving into their adult size enclosure. 
    • For a burrower, measure the depth of diggable substrate and anchor heavy rocks so digging underneath can’t shift them.
    • For an arboreal species, trace a route along the branches. Can they reach an elevated hiding spot, drinking water and a cooler perch under cover?

  • Check the warm end, cool end and basking surface. Use digital probe thermometers to measure air temperature on both ends.
    • For a basking species, also aim an infrared thermometer directly at the rock or branch where their body will rest.
    • The surface can be much hotter than the air above it. Such as when you're at the beach, the sand is much hotter than the grass even though the sun on your shoulders is the same temperature. 
    • Record each reading once the enclosure has warmed up, then check the overnight low before the lights come on.

  • Test the heat controls. Use a thermostat suited to your heat source (dimming or non dimming) and secure its probe as the manufacturer directs. Check the result with a separate thermometer. If the basking spot is on target but the cool hide is too warm, your reptile still needs somewhere cooler to retreat. Adjust the setup and measure both areas again.
    TIP: The cool side is usually the ambient temp of your room at its coldest. 

  • Track humidity between mistings. Place a digital hygrometer at the height your animal uses, away from direct spray. If you mist, record the relative humidity (%) once the droplets settle and again just before the next misting. Compare the high and low with your species preferred range. If the species uses a humid hide, check the moisture inside it separately. 
    TIP: With a mesh top, the humidity will be directly effected by the humidity level in your room. 

  • Check UVB at basking height. If you use UVB, measure from the lamp to where the top of your animal’s head or shell will sit when basking. Mesh reduces UVB, so check the distance chart for your exact lamp and fixture, including whether it sits above a screen. If you’re unsure which heat or UVB bulb you have, a clear photo of the label or packaging helps. Do not use a second hand lamp as they may be expired. For Arcadia fixtures, you can look up your species in the Arcadia UVB lighting guide.

What photos should I send?

  1. One photo of the whole enclosure. Step back far enough to show both ends and the top, including any fixtures above it.
  2. A closer look at anything hard to see. This might be a basking spot under a lamp, the depth of a burrowing area, or hides tucked behind plants.

In your message, include the animal’s name or species, the enclosure dimensions and the readings you measured. For example, if you measured two temperatures, tell us where you took each one. If you use UVB, include the bulb type and its distance from the basking spot.

Contact Roonami to send your enclosure photos before pickup.

What happens after I send my photos?

We’ll check whether the space, furnishings and conditions suit your animal. If something needs adjusting, we’ll explain what to change and why. Once we’ve approved the setup, we’ll confirm pickup or shipping with you.

Can I bring my pictures in store?

Yes! Just pull up your enclosure photos on your phone and we’ll go through them with you. A photo of the whole setup, including any lighting or heating above it, details on the bulbs such as UVB % and wattage, is a great place to start. Have your enclosure dimensions and temperature and humidity readings handy, too.

If you’re hoping to take your critter home that day, we recommend sending your everything ahead of time so you can make any adjustments before the trip.

 

Still getting ready? Our complimentary 7 day hold starts once we receive payment in full, giving you time to finish the enclosure while your animal stays in our care. See how the hold works.

Leave a comment

Your email address will not be published

Create an account

Having an account with us will allow you to check out faster in the future, store multiple addresses, view and track your orders in your account, and more.

Register

Recently added

You have no items in your shopping cart

Total excl. tax:C$0.00
E-mail Transfer (EMT) Credit Card

Calculate shipping costs

No shipping methods found for this country